6. Install the new switch(es) in the mounting hole(s); thread a switchboot onto each switch, and
use the switch boot tool to secure the switch(es) in place.
7. Align the LED’s with their respective openings.
8. Slide the PC board back into the slots in the upper Litebox housing.
a. Route any excess switch and lamp wiring into the well where the switch is located.
b. Install the power input connector in the bottom housing of the Litebox .
1 . Place the power input connector (slot side up) through the rear opening in the bottom
housing and snap the connector into place.
2. Secure the connector in place with the retaining screw.
3. Remove the slack from the wire between the connector and the printed circuit board by
pulling the wire from the component side of the board (see illustration).
9. Install the battery and reassemble the Litebox as shown in Section I.
- 17 –
