2. Place the open end of the strain relief tool over the strain relief and direct the wire leads
through the open channel in the tool (see illustration).
3. Apply pressure until the strain relief is fully seated.
C. Route the wiring harness (slip-on connector end) through the opening in the back of the
lamp housing.
D. Reattach the lamp housing to the Litebox body and secure it in the down position ( the
lamp housing should be flush against the Litebox body).
E. Place the wire tie (P/N : 450073) through the anchor located on the interior of the lamp
holder and wrap it around the wiring harness (do not tighten the wire tie).
- 13 –
