Dimension BST 1200 / SST 1200 User Guide
Troubleshooting 63
14. If material did not extrude from both tips follow the procedure in
the following section,
"Recovering From Loss of Extrusion"
.
Recovering From Loss of Extrusion
NOTE
It is recommended that you read and understand this entire
procedure before performing any of the work.
1. Enter
Head Maintenance
mode.
•
From
Idle
, press
Maintenance >
then
Next
> then
Head Maintenance
.
2.
Remove plastic head cover.
•
Remove plastic head cover by squeezing raised pads on
sides of cover. (
Figure 15 on page 47
)
3.
Place the tip toggle bar in neutral position (bar will extend
equally from both sides of head -
Figure 26
). This can be done
manually - push on the extended bar end.
Figure 26: Tip Toggle Bar in Neutral Position
WARNING
The head area is very hot!! Use leather
gloves when working in this area of
printer!
Toggle Bar extends equally
from both sides of head.
Liquefier
Tubes
