56 Maintenance
Dimension BST 1200 / SST 1200 User Guide
H. Use 7/64 T-Handle Allen wrench to firmly tighten the
heater block clamp screws.
NOTE
Make sure Tip remains all the way up against the heater
block as you tighten the screws.
Figure 24: Installation Examples
5.
Repeat steps 3 & 4 for second tip if necessary.
6.
Replace Plastic Head Cover and close the printer door.
7.
The printer will display
Tip Maintenance - Tips
Replaced?
- select
Yes
to begin material load.
A. The printer will display
Load Model - Replace Both
Cartridges
(flashing).
•
If you want to replace a material cartridge, do so now
(See
"Unloading Material"
, paragraphs
2
and
3 on
page 36
and
“Loading Material” on page 32
).
•
If you do NOT want to change a material cartridge, you
must unlatch and latch the cartridges to continue
(Press the cartridge forward to unlatch, then press it
forward again to latch).
NOTE
Because the material ‘unloaded’ during the tip
replacement, the printer is in a material replacement
mode. You must unlatch/latch the cartridges to continue.
If there is a delay in the unlatch/latch process, the
printer will display
Both Cartridges Not
Replaced Or Invalid
. Select
Retry
, then unlatch/
latch the cartridges.
