Strata EZIMIG185C, Operating Instructions Manual

Page: 8 / 48

The EZIMIG185C does not require any special maintenance, however the user should take care of the
machine as follows:
1. Regularly clean the ven la on slots
2. Keep the casing clean
3. Check all cables before use
4. Check electrode holders, work lead/clamps and welding torches before use
5. Replace worn electrode holders and earth clamps, which do not provide a good connec on
6. Replace worn torch consumable parts in a mely manner
7. Replace worn wire drive components in a mely manner
8. Use a so cloth or brush to clean electrical components. Do not use liquid cleaning products,
water or especially solvents
9. Do not use compressed air to clean electrical components as this can force dirt and dust further
into components, causing electrical short circuits
10. Check for damaged parts
WARNING! Before performing cleaning/maintenance, replacing cables/connec ons,
make sure the welding machine is switched off and disconnected from the power
supply.
If damaged, before further use, the welder must be carefully checked by a qualified person to determine
that it will operate properly. Check for breakage of parts, moun ngs and other condi ons that may affect
its opera on.
Have your welder repaired by an expert. An authorised service centre should properly repair a damaged
part.
This appliance is manufactured in accordance with relevant safety standards. Only experts must carry out
repairing of electrical appliances, otherwise considerable danger for the user may result.
Use only genuine replacement parts. Do not use modified or non-genuine parts.
When not in use the welder should be stored in the dry, dust-free and frost-free environment.
3. CARE & MAINTENANCE
3.1 Keep your Welding Machine in Top Condition
3.2 Storing the Welder
7
www.strata.co.nz
EZIMIG185C