5.12 MIG Torch /Spool Gun control
5.12.1 Parts Diagram for the MIG GUN
5.12.3 The operation for the MIG GUN
1. Service the wire feed mechanism at least every time the reel is changed.
• Check the wear of the feed roll groove and change the feed roll when necessary.
• Clean the welding gun wire guide with compressed air.
2. Cleaning the wire guide
Pressure of the feed rolls remove metal dust from the filler wire’s surface which then finds its
way to the wire guide. If the wire guide is not cleaned, it gradually clogs up and causes wire feed
malfunctions. Clean the wire guide in the following manner
：
• Remove the welding gun’s gas nozzle, contact tip and contact tip’s adapte r.
• With a pneumatic pistol, below compressed air through the wire guide.
• Blow the wire feed mechanism and reel housing clean with compressed air.
• Reattach the welding gun’s parts. Tighten the contact tip and contact tip’s ad apter to spanner tightness.
5.12.2 Binzel MT250 MIG Torch Range Parts
1.
MSS2557
Shroud Spring
2.
MSN2554
Swan Neck Assembly
5.
UG8015
Handle Cable Support C/W Ball Joint
9.
B2514
Ergo Handle Kit C/W Lock Nut
10.
UG2516
Medium / Large Ergo Trigger
19.
MOR1596
Gun Plug ‘O’ Ring
20.
MLN1597
Liner Nut
All products conform to EN60974-7 and are RoHS, REACH and WEEE compliant
18
www.strata.co.nz
EZIMIG185C
Summary of Contents for EZIMIG185C
Page 12: ...Figure 33 Figure 34 Figure 35 Figure 36 11 www strata co nz EZIMIG185C ...
Page 43: ...9 3 Electrical schematic drawing 42 www strata co nz EZIMIG185C ...
Page 45: ...44 www strata co nz EZIMIG185C ...
Page 46: ...45 www strata co nz EZIMIG185C ...
