5. Do not touch live electrical parts. Wear dry, insula ng gloves. Do not touch the electrode or the
conductor tong with bare hands. Do not wear wet or damaged gloves.
6. Protect yourself from electric shock. Do not use the welder outdoors. Insulate yourself from the
work piece and the ground. Use non-flammable, dry insula ng material if possible, or use dry
rubber mats, dry wood or plywood, or other dry insula ng material large enough to cover the
area of contact with the work or the ground.
7. Avoid inhaling fume. Some fume created by welding contain chemicals known to cause cancer,
birth defects or other harm. Your risk from these exposures varies, depending on how o en you
do this type of work. To reduce your exposure to these chemicals, work in a well-ven lated area,
and work with approved safety equipment, such as dust masks that are specially designed to
filter out microscopic par cles.
8. People with pacemakers should consult their physician(s) before using this machine.
WARNING! Electromagne c fields in close proximity to a heart pacemaker
could cause interference, or failure of the pacemaker. The use of a Welder is NOT
RECOMMENDED for pacemaker wearers. Consult your doctor.
9. Ensure that the unit is placed on a stable loca on before use.
WARNING! If this unit falls while plugged in, severe injury, electric shock, or
fire may result.
10. Transporta on Methods. Li unit with the handles provided, or use a handcart or similar device
of adequate capacity. If using a fork li vehicle, secure the unit to a skid before transpor ng.
CAUTION! Disconnect input power conductors from de-energized supply line
before moving the welding power source.
11. Exercise good work prac ces. The warnings, precau ons, and instruc ons discussed in this
instruc on manual cannot cover all possible condi ons and situa ons that may occur. It must be
understood by the operator that common sense and cau on are factors which cannot be built
into this product, but must be considered by the operator.
12. Do not use this machine for pipe thawing. This machine was not designed for pipe thawing and
will be a significant electrical & heat hazard if a empt is made to use for thawing pipe.
34
www.strata.co.nz
EZIMIG185C
Summary of Contents for EZIMIG185C
Page 12: ...Figure 33 Figure 34 Figure 35 Figure 36 11 www strata co nz EZIMIG185C ...
Page 43: ...9 3 Electrical schematic drawing 42 www strata co nz EZIMIG185C ...
Page 45: ...44 www strata co nz EZIMIG185C ...
Page 46: ...45 www strata co nz EZIMIG185C ...
