Do not lift the appliance by the
door handle
■
Remove the fixing screws from the
polythene bag on the top of the
appliance, but leave the appliance
in the base tray packaging until you
are ready to install it.
■
NOTE
: When removing the appli-
ance from the base tray packaging
care should be taken to ensure the
outer frame trim is not damaged.
❏
When installed in a typical 600 mm
deep built in housing unit, the false
back should be removed from the
housing unit, to provide the neces-
sary depth for installation.
❏
When the false back is removed, it
is normally the case that the support
shelf for the appliance leaves a gap
between the back edge of the sup-
port shelf and the rear wall of
approximately 80 mm.
❏
If no gap occurs between the back
edge of the shelf and the wall
behind the unit, we recommend that
a gap of at least 30 mm is made by
shortening the support shelf.
❏
If a top shelf is fitted, it must have a
gap at the rear of at least 50 mm,
but ensure items will not be dropped
behind the oven.
I
MPORTANT
:
D
O NOT MODIFY THE OUTER
PANELS OF THIS APPLIANCE IN ANY WAY
.
INSTALLATION INSTRUCTIONS
min
560 mm
550 mm
min
min
880
mm
869
mm
892
mm
min
888
mm
min
7 mm
547 mm
595 mm
550 mm
17 mm
6 mm
30 - 80
mm
BACK EDGE OF
SUPPORT SHELF
FRONT OF
OVEN
REAR
WALL
50
mm
17
18291 01 04/11/2002 12:19 Page 19
