Storz 11302 BDX, Instruction Manual

Page: 49 / 64

Troubleshooting
Symptom Possible causes Remedy
Image unclear
Distal objective lens fogged Rinse lens
Dirty lens. Withdraw Flexible Intubation Video Endoscope and clean
distal lens with cotton tip applicator and alcohol.
Lens water-damaged. Send Flexible Intubation Video Endoscope to KARL STORZ
for repair.
Inadequate lighting
Light conducting fibers damaged. Send Flexible Intubation Video Endoscope to KARL STORZ
for repair.
Light does not function
Not connected to power. Connect to power.
Complete failure of the unit
No power from power line Check the electrical supply
Possible lighting up of status display
Power cord connector is not properly connected to power Push power cord connector firmly into the power cord
cord receptacle receptacle
System error Carry out reset (see page 24).
No image, TFT screen is dark
Defective camera electronics Send Flexible Intubation Video Endoscope to KARL STORZ
for repair.
TFT screen defective Send TFT screen to KARL STORZ for repair.
Color distortions
White balance correct Carry out new white balance.
TFT screen defective Send TFT screen to KARL STORZ for repair.
Incorrect color setting on the monitor Set the color on the monitor (see page 17).
Image cannot be saved
No memory card inserted Insert memory card.
Memory card full Change memory card.
Video stream cannot be played back
No MPEG-4 codec installed Install an MPEG-4 codec on the PC
on the PC monitor
.
Troubleshooting
49