17
16
7. C O M M I S S I O N I N G A N D O P E R AT I O N
The
PLENTY
Hot Air Genera-
tor is equipped with a temper-
ature safety regulator.
When the auto off release handle is
first activated and the set temperature
is reached, the heating process is ter-
minated and the heater is turned off.
If the auto off release handle is pressed
while the
PLENTY
is held in the hand
during operation, then the set tempera-
ture level will be automatically retained.
Once the temperature of the heat ex-
changer cools off, an automatic reheat-
ing will not occur; instead the cooling
process continues until the orange
auto off release handle is pressed
again.
As soon as the orange control lamp
turns off, the set temperature has been
reached, and the heat exchanger’s
warming process is complete. Once
the desired preset temperature has
been reached, the vaporization cycle
can begin.
The current temperature can be read
from the thermometer.
If the temperature falls during vapori-
zation, then it is necessary to press the
auto off release handle again to restart
heating.
For technical reasons it is not
possible to measure the tem-
perature in the Filling Cham-
ber during the inhalation process. The
thermometer measures the tempera-
ture of the heat exchanger, and a cor-
responding calibration displays the
respective temperature in the Filling
Chamber during inhalation.
The auto off release handle
may not be fixed in the activa-
tion position (such as by tap-
ing or glueing it down). The manufac-
turer cannot accept any liability
whatsoever for damages caused by
alterations to the device or fixation of
the auto off release handle.
In case you prefer to keep the
PLENTY
standing up instead
of laying it on its side, you can
use the Cleaning Brush as a support,
by inserting the wooden handle in the
screwhole next to the rubber foot, as
shown.
Standing up the
PLENTY
Hot Air Generator
7.2. Temperature Setting
The vaporization temperature may
fluctuate by up to ±3% in comparison
to the stated values because of the
heating and cooling processes in the
heat exchanger.
Select the desired temperature with
the adjustment wheel of the tempera-
ture safety regulator.
Choose temperature
7. C O M M I S S I O N I N G A N D O P E R AT I O N
