25
24
Take the Mouthpiece between the
lips, and inhale slowly and evenly for
several seconds.
Please note the following about vapor
generation: the more intense the va-
pors, the greater the impairment of
the flavor.
A very high intensity (density)
of the vapor can lead to irrita-
tion of the respiratory pas-
sages from the concentration of the
aromas and fragrances.
In this case, the temperature should
be lowered, so that the intensity of the
vapors is reduced.
The
PLENTY
Vaporizer is intended to
be used while seated.
The device is not to be used,
if the user has respiratory
tract or lung conditions. De-
pending on the density, the vapor
could irritate respiratory tracts or
lungs, which can lead to coughing.
Inhale only half the amount of
air you can normally manage.
Hold your breath for a few sec-
onds and then exhale slowly. It is advis-
able to deliberately concentrate on your
breathing process.
After vaporization, turn off the
PLEN-
TY
Hot Air Generator, unplug the
power cord, and let it cool down be-
fore putting the device away.
9. APPLICATION
10. DISASSEMBLING, CLEANING AND ASSEMBLING
Mouthpiece
Upper Tubing
Section (long)
Cooling Coil
Lower Tubing
Section (short)
Filling Chamber Cap
Upper Screen
Lower Screen
Filling Chamber
Cylinder
Filling Chamber
Housing
10.1.
Disassembling and Re-
assembling the
PLENTY
Vaporization Unit
Manual cleaning with alcohol (min. 90%) or
dishwashing soap. Replacement Cooling
Coils may also be purchased.
PLENTY
Vaporization Unit
Please allow the Vaporization Unit to
cool down before disassembling it.
The component parts of the Filling
Chamber, including the Cooling Coil
and the Mouthpiece must be thor-
oughly cleaned on a regular basis to
guarantee proper operation and pure
flavor.
For hygienic reasons, it is also neces-
sary to clean these components when
the device is to be used by a different
person.
Paper or cotton towels may be used
for manual cleaning; use alcohol (eth-
anol) for metal components (Filling
Chamber Cylinder, Screens, Cooling
Coil), and warm water with wash-up
liquid for plastic components (Filling
Chamber Housing, Mouthpiece, Tub-
ing Sections).
