15
14
Do not leave the device unat-
tended during operation.
Place the
PLENTY
Vaporizer
only on a hard, heat-resistant, flat, sta-
ble surface, never on soft surfaces or
flammable material. Check whether
the power supply voltage corresponds
to the voltage rating listed on the de-
vice. The power cord and plug must be
in perfect condition. Connect the de-
vice only to a properly installed (elec-
trically grounded) socket.
7.1. Heating Up
Turn the device on with the
orange power switch (it is rec-
ommended to fill and attach
the Filling Chamber and Cooling Coil
before warming up the Hot Air Gener-
ator).
The power switch lights up to show
that the heater is operative. If the auto
off release handle has already been
activated, then the heating process
begins automatically.
Otherwise the heating process must
be started by pressing the orange
auto off release handle.
The heating process is in progress
when the orange control lamp is
lit. The desired temperature may be
set with the temperature adjustment
wheel. Warming up the heat exchang-
er may take up to 4 minutes, depend-
ing on the temperature set.
Press the auto off release handle to activate
the heating process
7. C O M M I S S I O N I N G A N D O P E R AT I O N
6 . T H E H O T A I R G E N E R AT O R
PLENTY
Vaporization temperature scale
130°C
266°F
142°C
288°F
154°C
310°F
166°C
331°F
178°C
352°C
190°C
374°F
202°C
396°F
7. C O M M I S S I O N I N G A N D O P E R AT I O N
If the preceding tips do not
yield the desired results, or
for any other defects or prob-
lems not mentioned here, please un-
plug the power plug and contact our
Service Center immediately.
Do not open the Hot Air Gen-
erator! Without special tools
and specialized knowledge,
any attempt to open the device will
cause damage to it. Such an attempt
will invalidate the warranty claim.
Do not try to remedy the defect your-
self. Contact our Service Center di-
rectly.
Disposal
If the Hot Air Generator is irreparably
damaged, please do not simply throw
it away. As it is made of high qual-
ity, completely recyclable component
parts, it should be brought to a mate-
rial recycling center in your town or
sent to our Service Center for disposal.
The manufacturer will not bear any
responsibility whatsoever if this acci-
dent prevention measure is not taken.
Please unplug from the mains socket
to completely disconnect from the
mains power supply.
