![background image](http://html.mh-extra.com/html/storm/vudo2ptzir30x/vudo2ptzir30x_installation-manual_1382791013.webp)
5
are two connection modes which are shown in Figure 1-5.
1-2
2-3
120Ω
ON
OFF
Figure 1-5
The factory default connection mode is shown in Figure 1-6, the jumper (connection board) is
plugged into pin2 and pin 3, which means 120Ω resistance is not connected to the device.
Figure 1-6
If you want to connect the 120Ω resistance, you have to pull the jumper out of pin 2 and pin 3,
and connect to pin 1 and pin 2, then 120Ω resistance is connected to the circuit, see Figure 1-7.
Figure 1-7
1.5
Reset and SD Card Installation (For network speed dome only)
You can see there is a RESET button and Micro-SD card slot on the PCB after you open the dial
switch cover. See Figure 1-8. Reset button is used to reset network system. Micro-SD card is
used to save the data.
Summary of Contents for VUDO2PTZIR30X
