3
setup don’t have to be conducted.
1.4.1 Initial Setup
Address: 1
Baud rate: 9600
Parity: None
120
Ω
matched resistance
：
OFF
1.4.2 Dial Switch Setup (For Intelligent Speed Dome Only)
Users must set the address, Baud rate and parity which are used by the speed dome before
controlling it. Only after all these setup, can the speed dome respond to its control commands.
Note:
Users must reboot the speed dome after resetting some specifications, which makes the new
setup take effect.
There are two dial switch buttons on the speed dome PTZ which are used to confirm the
specifications of address and Baud rate, parity. It is 1 when you set the button as ON. For address
setup dial-up, 1 is the lowest bit, 8 is the highest bit; for the Baud rate and parity setup dial-up, 1 is
the lowest bit, 4 is the highest bit, see Figure 1-2. (Intelligent speed dome self- adaptive PELCO-
D, PELCO-P,
industrial standard protocol, control protocol don’t need dial switch setup).
Summary of Contents for VUDO2PTZIR30X
