AXS Strikemaster
Engineering Manual
AXS Strikemaster Programming and Operation Manual May 2013 Page 18 of 22
For more information visit
www.storm-interface.com
© Copyright Storm Interface. 2013. All rights reserved
2/ The Keypad appears to be have lost its entry codes
The STORM AXS StrikeMaster keypad stores all programmable options in a non-volatile memory location.
This means that all codes and settings programmed into the keypad will be saved even if the power supply is
switched off or there is a power cut.
In certain installations it may appear that the entry codes have been erased, however, it is not the case.
This can occur as a result of electrical noise from a peripheral device (i.e. a noisy electric strike or magnetic
lock). In a very few cases external interference, such as short term interruption to the power supply, could
cause some electronic components to re-set whilst others are still active.
The result is a semi active keypad that does not perform correctly in that the strike time has re-set to zero
seconds and you might assume that the entry code has been erased.
A time of 01 second to 99 seconds can be programmed.
If the above situation is suspected the following routine should be carried out:-
1. Check that all connections to the keypad, power supply and locking device are still secure. Ensure
that the suppresser ( Metal Oxide Varistor "MOV" ) is connected across the lock terminals. Ideally
this should be located as close to the lock as possible.
2. Reset a workable strike time as follows:
Log in by entering the known Engineers Code
#XXXXXX
Select door 1 or door 2 by entering
-
5 Door 1
6 Door 2
Enter the required 2 digit Strike Time - eg
05 (5seconds)
Log
off
by
entering
- 0
Note: If after this process the Strikemaster is powered down the Strike Time will automatically reset to 5
seconds.
3/. How do I add and delete codes?
To add use Option 1 (to add a code)
Log in by entering the known Engineers Code
#XXXXXX
Press 1 to add a code
1
Enter the index number where the code is to be e.g. 12
Choose e.g Door 1 Timed
1
Select the number of digits that will be in the code e.g. 4
Type in the new code
e.g. 1234
Log
off
by
entering
0
To delete use Option 2 (to delete a code) in Programming Mode
- see Programming Flowchart on the last
page
4/. What power supply do I need for a Strikemaster?
StrikeMaster power supply (11v-28v DC) recommended minimum 12v dc 500mA, preferable 12v dc 640mA.
Available from haredata.co.uk
