Storch Airless ST 450, Original Instruction

Page: 140 / 196

140 Original instruction
2. Use a smaller tip size and/or dilute the coating materi-
al if pressure adjustment cannot eliminate stripes (please
observe the manufacturer's instructions here).
3. Hold gun perpendicular, 25 - 30 cm from the surface.
Spray back and forth within width; overlap by 50 %.
4. Trigger gun after moving. Release trigger before stop-
ping.
Clear Tip Clog
In the event that particles or debris clog the spray tip, this
sprayer is designed with a reversible spray tip that quickly
and easily clears the particles without disassembling the
sprayer.
1. Engage trigger lock. Rotate spray tip 180° to unclog
position. Disengage trigger lock. Point the spray gun at
the waste pail and briefly pull the trigger to unclog it.
NOTE: If spray tip is difficult to rotate when turning to
the unclog position, perform Pressure Relief Procedure,
then turn circulation valve to spray position and repeat
step 1.
2. Engage the trigger lock. Rotate spray tip back to spray
position. Disengage trigger lock and continue spraying.
Processable ma-
terials
Glazes
Alkyd resin lacquer
Acrylic lacquer
Primers
Pre-coats
Interior emulsions
Exterior emulsions
Adhesive for fibreglass wallpaper
Flame protection
Bitumen material
Light filler
Other spray fillers
Nozzle drilling in 1/1000" (example: 8 = 0.008") and nozzle marking
Spray width 7 9 10 11 12 13 15 17 19 21 23 25 27 29 31 33 35 37 39 41 43
10 cm 207 209 210 211 212 213 217 219 235
15cm 307 309 310 311 313 315 317 319 321
20cm 409 410 411 413 415 417 419 421 423 425 431
25cm 511 513 515 517 519 521 523 525 527 529 531 535 543
30cm 619 621 623 625 627 631 633 635 637 639 641 643
35cm 721 735
QuickClean cleaning adapter for efficient cleaning
The QuickClean adapter requires a water connection, a
water hose with connection coupling (e.g. Gardena) and a
bucket to collect the dirty water.
Proceed as follows:
1. Ensure the Airless
gun trigger has been
locked and the rever-
sing tip has been
removed from the tip
holder.
2. Remove the vacu-
um hose from the
container and clean it
(including vacuum fil-
ter) on the outside with
water or a compatible
solvent. Unscrew the
vacuum filter from the
vacuum pipe and clean
the container.
Nozzle table/nozzle selection guide