8
SYSTEM CONNECTION
The Storage Options IP Camera is designed to be connected to a suitable computer network.
NOTE
It is recommended that while configuring the IP Camera, the computer should be attached to the router
via RJ45 LAN cable, rather than over wireless connection.
To set up the IP Camera:
1.
Connect the IP Camera to a router via the included RJ45 LAN cable.
2.
Attach the included wireless aerial to the screw mount.
3.
Connect the IP Camera to a mains supply using the supplied 5V adapter.
4.
Give the IP Camera at least 2 minutes to power up. During this time the LED will flash and the lens will cruise
through its pan and tilt mode. Once the IP Camera stops moving, it is ready for use.
5.
Install the Windows software.
Refer to section “
Software Installation
” (page 9) for further instructions.
NOTE
The green I/O sockets are used for connecting to building alarm systems and are for advanced users only.
Storage Options cannot provide support on connecting to alarm systems.