STOKVIS ENERGY SYSTEMS ECONOFLAME R30, Installation Operation & Maintenance

Page: 14 / 36

10
Doc653/30CV02A
4.2 Packaging
The boiler is delivered in suitable cardboard packaging.
The types 45, 65, 85 and 100 can be stacked up till two pieces. It’s not allowed to stack up the
type 120.
4.3 Transport
x
Regarding transportation, refer to the technical data for dimensions and weights.
w
The packing should only be removed after transportation, or remove the panels before transpor-
tation. This is in order to prevent the panels from getting damaged.
Moving
Each boiler is packed in its own carton which has hand holed at both sides for lifting purposes.
Access requirements
The dimensions of the boiler are such that all the boiler types can be transported through a door
opening of 60 cm.
Mounting
Install the Stokvis R30 using a spirit level on a suffi ciently sturdy wall using the suspension
bracket provided. A template has been provided in the packing box, on which the positions of the
fi xing holes have been indicated.
Protection against frost
Boilers that are not used during the winter are in danger of freezing. Drain out the water from the
fi lling and drain valve.
5 Installation
5.1 Regulations
The appliance should be installed by a recognised installer in accordance with the applicable
national and local standards rules and regulations.
The commissioning should preferably be done by the Stokvis Service department to validate the
warranty.
5.2 Installation area
5.2.1 General
- Thanks to the design of the boiler, radiation losses are negligible
- Due to the low noise level, there is no need for additional sound insulation of the room
- Due to its compact design, very little installation space is required
- The location options for the boiler are increased because it is supplied suitable for both open
and room sealed operation (see chapter 5.3.4).
5.2.2 Installation
The following guidelines should be followed in order to optimise the installation of the boilers
- The device should be installed in a frost free room due to the risk of freezing of the condensate
drain. The built-in protection system is activated when the temperature of the central heating
water falls below 5°C
- Pay attention to the location and temperature sensitivity of the device.