4
2.5 CHECK COMPRESSOR FOR PROPER
POWER (3 PHASE ONLY)
After connecting the electrical, check that the compressor
is operating in the proper direction.
A.
Start a freezing cycle.
On the right side, place the Main Freezer Power
switch and Freezing Cylinder OFF/ON switch to
the ON position. Press the PUSH TO FREEZE
button.
On the left side, place the Clean/Off/Serve and
the Standby/Serve switches in the Serve position.
B.
The suction line will be cold to the touch within 1
minute.
C.
If it is not, disconnect power to the machine and
reverse L1 and L3 lines in the junction box.
D.
After reversing the electrical lines, recheck the
suction line.
2.6 CHECK BLENDER ROTATION
After connecting the electrical, check the blender on the
right side for proper rotation.
A.
Place the Blender Power Off/On switch to the ON
position.
B.
With the clear swing sheild in place, move the
spigot handle to the right.
WARNING
Hazardous Moving Parts
Blender shaft and agitator can grab and cause
injury. Do not operate blender without protective
shield or swing splash shield.
C.
The blender should rotate clockwise looking from
the top of the blender.
D.
If the rotation is counterclockwise, refer to the
wiring diagram located behind the header panel
and check the diode direction. Reverse the diode
polarity if needed.
2.7 MIX PUMP
A. MIX PUMP HOSE INSTALLATION
Follow the steps below to install the mix pump hose in
the cabinet part of the machine.
1.
Turn the mix pump on. The switch is located on
the header panel.
2.
Feed one end of the mix pump hose into the
entering or pickup hose side (left) of black cover
(Fig 2-2).
NOTE
Feed the tube into the clamp so the natural curve of
the tube is towards the outside of the black cover.
This prevents the hose from looping around the
black cover twice.
3.
Gently push the hose into the black cover until it
begins to feed.
Figure 2-2 Mix Hose Installation
6” (15cm)
