Stoelting E131G, Service Manual

Page: 13 / 80

5
Fig. 7. Floor Stand
2.4 FLOOR STAND INSTALLATION
To install the E/F 131 on to the floor stand, follow the
steps outlined below:
1. Uncrate the floor stand and place in an upright
position.
NOTE
Detailed instructions are included with each floor
stand.
2. Place a spirit level across the top of the stand to
check for level condition, side to side and front to
back. If adjustment is necessary, level the stand by
turning the bottom part of each caster in or out, then
tighten the lock nut, and lock caster.
3. Remove the four legs from the freezer and replace
with the four leg adapters provided. Adapters must
be fully tightened to the freezer.
4. Place the E/F131 freezer on the floor stand with the
front of the freezer to the door end of the stand.
Secure the freezer to the stand with the nuts and lock
washers provided. Then separate freezer base gasket
and install the seam to the back and the flat to the
bottom (Fig. 7).
2.5 INSTALLING PERMANENT WIRING
WARNING
ELECTRICAL TECHNICIANS MUST BE
CONTINUOUSLY ALERT TO THE PRACTICE
OF ALL NECESSARY SAFETY RULES AND
PRECAUTIONS WHEN SERVICING THIS
EQUIPMENT AS VOLTAGES ARE PRESENT
WHICH CAN CAUSE SERIOUS OR FATAL
INJURY.
ELECTRICAL WIRING MATERIALS,
ARRANGEMENT AND GROUNDING MUST
CONFORM WITH NATIONAL AND OTHER
APPLICABLE ELECTRICAL CODES.
If permanent wiring is required by local codes, the
following procedure must be performed:
A. Remove the back panel.
B. Disconnect the wires from the terminal block. Discon-
nect the green ground wire from the grounding stud.
C. Remove the power cord.
D. Install permanent wiring according to local code.
E. Replace the back panel.
Figure 8. Power Cord Connection