Stoelting E112-LJ, Operator'S Manual

Page: 22 / 29

16
4.3 TROUBLESHOOTING - AUTO FILL SYSTEM
4.2 TROUBLESHOOTING - CONTINUED
PROBLEM
1 No vent space for free flow of cooling
air. 1 A minimum of 6" of air space on both sides (the
E112 requires 3"). (See Section 2)
2 Condenser is dirty. 2 Clean. (See Section 3)
3 Consistency setting too soft. 3 Turn Consistency Adjustment knob clockwise.
4 Auger is assembled incorrectly. 4 Remove mix, clean, reassemble, sanitize and
freeze down.
5 Auto Fill Pump not operating. 5 See Auto Fill Troubleshooting section.
6 Refrigeration problem. 6 Check system. (Call distributor for service)
1 No mix in hopper. 1 See Auto Fill Troubleshooting section.
2 Drive motor overload tripped. 2 Wait for automatic reset. (If condition
continues, call distributor for service.)
3 Drive belt failure. 3 Replace drive belt.
4 Freeze-up (Auger will not turn). 4 Turn Clean/Off/On switch Off for 15 minutes,
then restart.
1 Worn drive belt. 1 Replace drive belt.
2 Freeze-up (Auger will not turn). 2 Turn Clean/Off/On switch Off for 15 minutes,
then restart.
3 Not tensioned properly. 3 Adjust belt tension
1 Outside surface of rear auger seal is
lubricated. 1 Clean lubricant from outside of rear seal,
lubricate inside of seal and reinstall.
2 Rear seal missing or damaged. 2 Check or replace.
3 Seal o-ring missing, damaged or
installed incorrectly. 3 Check. or replace.
4 Worn or scratched auger shaft. 4 Replace auger shaft.
1 Front door knobs are loose. 1 Tighten knobs.
2 Spigot parts are not lubricated. 2 See Section 3.
3 Chipped or worn spigot o-rings. 3 Replace o-rings.
4 O-rings or spigot installed wrong. 4 Remove spigot and check o-ring.
5 Inner spigot hole in front door nicked or
scratched. 5 Replace front door.
Product does not
dispense.
Front door leaks.
Product is too thin.
Drive belt slipping
or squealing.
Rear auger seal
leaks.
POSSIBLE CAUSE REMEDY
1 Low water pressure. 1 Verify that there is adequate water pressure at
the inlet fitting (30-50 psi).
2 Restriction or plugged auto fill system. 2 Flush and sanitize the pump and tubing.
3 Empty BIB 3 Replace BIB
1 BIB connector is not connected to the
BIB properly. 1 Check connection and reconnect if necessary.
2 Leak at the connections or in the
tubing. 2 Look for leaks at the connections and bubbles
in the tubing. Tighten clamps and replace
tubing if necessary.
3 Air in the BIB syrup container. 3 Remove the air from the BIB syrup container.
4 Pump is clogged with debris or
particulates. 4 Remove syrup valves and inspect for debris or
improper closing that would interfere with
operation.
Syrup
concentration
incorrect
Pump does not
operate.