Stoelting E112-LJ, Operator'S Manual

Page: 16 / 29

10
D. Sanitize the hopper and freezing cylinder with
sanitizer. Be sure to clean the rear seal surfaces
inside the freezing cylinder.
E. Wipe down the outside of the machine and table
with a yellow sanitized towel.
3.6 ASSEMBLY OF MACHINE
To assemble the machine parts, refer to the following steps:
NOTE
Petrol Gel sanitary lubricant or equivalent must be
used when lubrication of parts is specified.
NOTE
The United States Department of Agriculture and
the Food and Drug Administration require that lubri-
cants used on food processing equipment be certi-
fied for this use. Use lubricants only in accordance
with the manufacturer’s instructions.
A. Wash, rinse, dry and sanitize hands before starting.
B. Place the rear seal o-ring onto the auger and apply
a thin film of Petrol-Gel to the o-ring.
C. Assemble the rear seal onto the auger with the
large end of the seal to the rear. Lubricate the hex
end of the auger with a small amount of spline
lubricant.
D. Install the plastic auger blade onto the auger. Push
the auger into the freezing cylinder and rotate it
slowly until the auger engages the drive shaft.
E. Assemble the o-rings onto the spigot body and
apply a thin film of Petrol-Gel onto the o-rings.
F. Insert the spigot body into the front door.
NOTE
When inserting the spigot body, press the o-rings
against the spigot to prevent damage.
Figure 3-5 Cleaning Freezing Cylinder
CAUTION
Do not allow sanitizer to remain in contact with stain-
less steel parts for prolonged periods. Prolonged
contact of sanitizer with machine may cause corro-
sion of stainless steel parts.
figure 3-6 Door and Stator Assembly
Torque
Rod
Auger
Support
Bushing
Stator Bar
Front O-Ring
Stator Bar
Bushing
Quad
Ring
Stator Bar
Stator Bar
Rear O-Ring