2 | User information
STOBER
6
02/2020 | ID 443025.06
2
User information
This documentation assists you with commissioning the STOBER SC6 or SI6 series drive controllers in combination with
higher-level controller systems over an EtherCAT network.
Technical knowledge
Operating an EtherCAT network requires having familiarity with the basics of the EtherCAT network technology.
Technical requirements
Before you begin operating your EtherCAT network, you need to wire the drive controllers and initially check that they are
functioning correctly. To do so, follow the instructions in the commissioning instructions for the SC6 and SI6 drive
controllers.
2.1
Storage and transfer
As this documentation contains important information for handling the product safely and efficiently, it must be stored in
the immediate vicinity of the product until product disposal and be accessible to qualified personnel at all times.
Also pass on this documentation if the product is transferred or sold to a third party.
2.2
Described product
SC6 or SI6 series drive controller in conjunction with the DriveControlSuite software (DS6) in V 6.4-E or higher and
associated firmware in V 6.4-E-EC or higher.
2.3
Timeliness
Check whether this document is the latest version of the documentation. We make the latest document versions for our
products available for download on our website:
http://www.stoeber.de/en/downloads/
2.4
Original language
The original language of this documentation is German; all other language versions are derived from the original language.
2.5
Limitation of liability
This documentation was created taking into account the applicable standards and regulations as well as the current state of
technology.
STOBER shall assume no responsibility for damage resulting from failure to comply with the documentation or from use
that deviates from the intended use of the product. This is especially true for damage caused by individual technical
modifications to the product or projecting and operation of the product by unqualified personnel.
