Stobag MOVENO DSRCE-V, Installation And Use Instructions And Warnings

Page: 27 / 44

www.stobag.com
GB
27
2) Installation
Incorrect installation could cause serious injury.
Proceed as follows to prepare the motor:
1. Position the limit switch crown (E) on the motor (A) until it fits into the corresponding limit
switch ring (F); make sure that the two grooves match. Push it into position as shown
in Fig. 5.
2. Mount the drive wheel (D) on the motor shaft.
On MOVENO-U the drive wheel (D) snaps on automatically.
3. Fit the assembled motor into the winding roller until the crown (E) is fully inserted. Fasten the drive wheel (D) to the winding roller using the
M4x10 screw, so as to prevent the motor from slipping or sliding axially (fig. 6).
4. Finally, secure the motor head to the special support (C) with the spacer (if any), using the clips or split pin (B).
A: MOVENO DSRCE-V Tubular motor
B: Fastening clips or split pins
C: Support and spacer
D: Draw lock ring
E: Idle lock ring
F: Idle ring
2.1) Electrical connections
For motor connections, an omnipolar disconnecting
device with a 3-mm minimum distance between contacts
must be provided for disconnection from the mains power
supply (disconnecting switch or plug and socket, etc.).
Carefully follow all the connection instructions, if you
have any doubts do not make experiments but consult the
relevant technical specifications sheets which are also
available on the web site www.stobag.com.
An incorrect connection may be dangerous and cause
damage to the system.
The cable used for the electrical connections of the MOVENO
DSRCE-V motors has 5 wires; 3 of the wires (yellow tag) are for the
mains power supply and 2 wires (green tag) are for the command
signals.
For the electrical connections see the diagram below. The connec-
tion devices are not supplied with the product.
PIN¬CONNECTION¬WITH¬(IRSCHMANN¬34!+¬¬34!3¬¬
L
N
PE
3x1.5mm
2
LNPE
(230VAC / 50Hz)
5x0.75mm
2
3 2 1 4
1 2 3 4
1 3 PE 4 2
M1
~
1 3 PE 4 2
M1
~
1 3 PE 4 2
M1
~
1 3 PE 4 2
1 3 PE 4 2
1 3 PE 4 2
å BLACKWHITEå COMMONå6 å
å WHITEå STEPBY3Tå
å å 44"53åååååå
å BROWNå PHASEååå
å BLUEå NEUTRALå
0%å YELLOWGREENå EARTHå
PIN¬CONNECTION¬WITHOUT¬(IRSCHMANN¬34!+¬¬34!3¬¬
5x0.75mm
2
L
N
PE
3x1.5mm
2
LNPE
(230VAC / 50Hz)
M1
~
WHITEå STEPBY3Tå
å 44"53ååå
BROWNå PHASEå
BLUEå NEUTRALå
YELLOWGREENå EARTHå
BLACKWHITEå COMMONå6 å
MOVENO_DSRCE-V.indd 27 MOVENO_DSRCE-V.indd 27 9.2.2010 14:33:48 Uhr 9.2.2010 14:33:48 Uhr