Copyright © 2006 – STM Norway AS
Publication no. 101557, Rev. T, November 3
th
, 2006
Page 22
6. STM SatLink Terminal configuration
Before powering on the STM SatLink Terminal for the first time, ensure that the Tx coaxial cable from
the STM SatLink Terminal to the ODU is disconnected to avoid that incorrect and potentially damaging
signals are sent to the satellite. Follow all the procedures below when installing the STM SatLink
Terminal and lining up the ODU.
6.1
Power on and logon
1)
To view the boot processes of the STM SatLink Terminal, please connect a PC to the serial interface
and launch a Terminal Emulator as described in Appendix B. Otherwise go to step 2.
2)
Turn on the power of the STM SatLink Terminal.
3)
When turning on the STM SatLink Terminal first the Boot SW is loaded. A message such as the one
below is displayed on the CLI/RS-232 when the boot SW starts. Telnet is not available until the
application has been started.
STM SatLink Boot-loader
- SW ID 106267, Revision 9.0.0.1
File system initialised
Press return to enter boot-loader
Under normal circumstances the user should not need to enter the boot-loader and should ignore the
“press return to enter boot-loader” message. The DVB RCS application will load automatically once
the boot SW load has completed. See Appendix K for further details concerning the boot SW. If
access to the boot-loader is required, press return within 10 seconds to display the login-prompt for
entering the boot-load. After the timer has expired, the DVB-RCS application will be loaded. The
message
Loading application
will be shown when the application starts to load.
