Still RX50-10, Original Instructions Manual

Page: 319 / 374

Maintenance
6
Safety regulations for maintenance
To prevent damage to electronic systems
with electronic components, such as an
electronic driving regulator or lift control, these
components must be removed from the truck
prior to the start of electric welding.
Work on the electrical system (e.g. connecting
a radio, additional headlights etc.) is only
permitted with approval from the authorised
service centre.
Safety devices
After maintenance and repair work, all safety
devices must be reinstalled and tested for
operational reliability.
Set values
The device-dependent set values must be
observed when making repairs and when
changing hydraulic and electrical compo-
nents. These are listed in the appropriate
sections.
Lifting and jacking up
DANGER
There is a risk to life if the truck tips over!
If not raised and jacked up properly, the truck may
tip over and fall off. Only the hoists specified in the
workshop manual for this truck are allowed and are
tested for the necessary safety and load capacity.
– Only have the truck raised and jacked up by the
authorised service centre.
– Only jack the truck up at the points specified in
the workshop manual.
The truck must be raised and jacked up for
various types of maintenance work. The
authorised service centre must be informed
that this is to take place. Safe handling of
the truck and the corresponding hoists is
described in the truck’s workshop manual.
55048011501 EN - 12/2015 307