Still RX50-10, Original Instructions Manual

Page: 250 / 374

5
Operation
Operation in special operating situations
DANGER
Risk of accident from the truck crashing!
Steering movements can cause the tail end to veer
off the loading bridge towards the edge. This may
cause the truck to crash.
– Before driving over a loading bridge, ensure that
it is installed and secured properly.
– Ensure that the transport vehicle to be driven
onto has been sufficiently secured against
moving.
– Maintain a safety distance from edges, loading
bridges, ramps, working platforms etc.
– Drive slowly and carefully onto the transport
vehicle.
5060_003-170
1 1
Wedging
NOTE
Due to its design, the truck can only be
chocked securely if the fork carriage is raised
before chocking. To ensure secure parking
after chocking, the fork carriage can be
lowered as far as the chock.
– Raise the fork carriage high enough so that
the chocks can be inserted in front of the
front wheels.
– Secure the truck from rolling away by
placing a wheel chock in front of each front
wheel and behind the back wheel (1).
– Park the truck securely.
CAUTION
Risk of component damage!
If you remove the battery male connector while
the key switch is switched on (under load), an arc
will be produced. This can lead to corrosion at the
contacts, which considerably shortens their service
life.
– Switch off the key switch before the battery male
connector is disconnected.
– Do not disconnect the battery male connector
while the key switch is switched on, except in an
emergency.
– Ensure that the key switch is switched off.
– Disconnect the battery male connector.
238 55048011501 EN - 12/2015