Still LiftRunner B frames, Original Instructions Manual

Page: 16 / 108

2
Introduction
Use of the tugger train
Use of the tugger train
Intended use
The frames are intended solely for the follo-
wing purpose:
• Picking up and transporting trolleys loaded
with equipment in order to transport them to
a workplace and replace them with empty
trolleys
• A frame must only be loaded with the
trolleys intended for this purpose
• A B frame, C frame or E frame may only
be pulled by a suitably equipped (pneu-
matic/hydraulic/electrical) tow tractor (not
by a truck!)
• An autarkic E frame may only be pulled by
an appropriate tow tractor (not by a truck!).
WARNING
The frames are designed for a maximum speed of
15 km/h.
If a tow tractor is used that can travel faster than
15 km/h, its maximum speed must be limited to 15
km/h in order to guarantee safe operation of the
chassis.
The chassis may only be used for its proper
purpose as set out and described in these
operating instructions!
If the chassis is to be used for purposes
other than those specified in the operating
instructions, the approval of the manufacturer
and, if applicable, the relevant regulatory
authorities must be obtained beforehand to
prevent hazards.
Improper use
The operating company or driver, and not the
manufacturer, is liable for any hazards caused
by improper use.
Use for purposes other than those described
in these operating instructions is prohibited.
• A chassis may not be operated in areas
where there is a risk of fire, explosion or
10 50988046101 EN - 02/2017