The plug may come out of the drive tube when
you pull off the cap. Push it back into the drive
tube as far as stop.
413BA015 KN
A
► Apply a mark (with pencil or colored pen) at
distance A (40 mm) from the end of the drive
tube.
414BA008 KN
2
3
► Push the gearbox (2) onto the drive tube (3)
as far as stop – turn it back and forth at the
same time – until it reaches or covers the mark
on the drive tube.
Alternative check: The drive tube is correctly
positioned when it completely closes the slot in
the gearbox’s clamp (short arrows).
414BA009 KN
► Line up the gearbox parallel to the machine
support or the ground.
► Tighten down the clamp screws on the gear‐
box firmly.
4.2
Fitting the Tines
414BA025 KN
1
2
► Screw the tines (1) into the two rakes (2) by
hand as far as stop – fit all eight tines on the
rakes.
► Tighten down the tines by hand.
414BA026 KN
16 mm
2
4
1
3
► Engage the combination wrench (3) on the
hexagon (4) at the base of tine (1) and screw
down as far as stop.
4 Assembling the Unit
English
0458-422-0121-D
9