9
Starting / Stopping the
Engine
9.1
Controls
0208BA028 KN
2
1
4
3
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and Stop positions.
Depress the stop switch (
…
) to switch off the
ignition – see "Function of Stop Switch and
Ignition System".
4 Throttle set wheel – limits travel of throttle
trigger – see "Function of Throttle Set Wheel".
9.1.1
Function of Stop Switch and Ignition
System
The stop switch is normally in the Run position,
i.e. when it is not depressed: The ignition is
switched on – the engine is ready to start. Oper‐
ate the stop switch to switch off the ignition. The
ignition is switched on again automatically after
the engine stops.
9.1.2
Function of Throttle Set Wheel
Travel of throttle trigger can be limited with the
set wheel:
–
Turn throttle set wheel in direction of – as far
as stop to limit travel to idle speed.
–
Turn throttle set wheel in direction of + as far
as stop to allow travel to full throttle.
–
The preset limit can be temporarily overridden
by squeezing the throttle trigger firmly.
9.2
Starting the Engine
5
0000-GXX-5224-A0
► Press the manual fuel pump bulb (5) at least
five times – even if the bulb is already filled
with fuel.
Cold engine (cold start)
2.
1.
6
0000-GXX-5475-A0
► Turn choke knob (6) and then push it in at
g
Also use this setting if the engine has been run‐
ning but is still cold.
–
Turn throttle set wheel in direction of + as far
as stop.
Hot engine (hot start)
► Choke knob (6) remains in
F
position.
9.2.1
Cranking
414BA013 KN
9 Starting / Stopping the Engine
English
0458-422-0121-D
13