![background image](http://html1.mh-extra.com/html/stihl/ms201t/ms201t_instruction-manual_1378794031.webp)
MS 201 T
English
29
N
Remove chain sprocket cover, saw
chain and guide bar
N
Release chain brake – pull hand
guard against the front handle
Fitting a new chain sprocket
–
after use of two saw chains or
earlier
–
if the wear marks (arrows) are
deeper than 0.5 mm – otherwise the
service life of the saw chain is
reduced – use check gauge (special
accessory) to test
Using two saw chains in alternation
helps preserve the chain sprocket.
For the removal and installation of chain
sprocket and clutch described in the
following, a locking strip is required to
immobilize the piston in the cylinder. The
locking strip is included with the
replacement chain sprocket.
STIHL recommends use of original
STIHL chain sprockets in order to
ensure optimal functioning of the chain
brake.
Removal
N
Pull off the spark plug boot
N
Unscrew spark plug (1)
N
Turn the clutch until the piston is in
the lower part of the cylinder
N
Insert the locking strip (2) through
the opening as far as it will go into
the cylinder
N
Fasten the locking strip (2) on the
cylinder fin
N
Turn the clutch clockwise until the
piston rests against the locking strip
N
Loosen the hexagon of the clutch
clockwise (left-handed thread)
N
Unscrew clutch
N
Remove chain sprocket (3) and
needle cage (4) from the crankshaft
N
Clean crankshaft stub and needle
cage and lubricate with STIHL
lubricant (special accessory)
Checking and Replacing the
Chain Sprocket
001BA120 KN
1
001
1BA031 KN
2
001
1BA037 KN
2
001
1BA032 KN
144BA017 LÄ
144BA018 LÄ