![background image](http://html1.mh-extra.com/html/stihl/fs-km/fs-km_instruction-manual_1378667022.webp)
FS-KM
English
20
N
Place the cutting attachment (6) on
the thrust plate (7).
WARNING
Collar (see arrow) must engage the
cutting attachment's mounting hole.
Securing the cutting attachment
N
Fit the thrust washer (8) – convex
side must face up.
N
Fit the rider plate (9).
N
Block the shaft (10).
N
Use the combination wrench (12) to
screw the mounting nut (11) on to
the output shaft counterclockwise
and tighten it down firmly.
WARNING
If the mounting nut has become too
loose, fit a new one.
NOTICE
Remove the tool used to block the shaft.
Removing the Metal Cutting Attachment
WARNING
Wear protective gloves to reduce the
risk of direct contact with the sharp
cutting edges.
N
Block the shaft.
N
Unscrew the mounting nut
clockwise.
N
Remove cutting attachment and its
mounting hardware from the
gearbox – but do not remove the
thrust plate (7).
The type and style of the harness,
carrying ring and carabiner (spring hook)
depend on the market.
The use of the harness is described in
the chapter on "Approved Combinations
of Cutting Attachment, Deflector, Handle
and Harness".
Shoulder strap
N
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
the carabiner (2) is about a hand’s
width below your right hip.
N
Balance the machine – see
"Balancing the Machine".
Fitting the Harness
1
002BA374 KN
2
Summary of Contents for FS-KM
Page 2: ...Instruction Manual 1 32 Manual de instrucciones 33 66 ...
Page 69: ...FS KM español EE UU 67 ...
Page 70: ...FS KM español EE UU 68 ...
Page 71: ......