Page 8
Technical Information 40.2010
TI_40_2010_13_01_02.fm
3.5.3
At temperatures above +20 °C
.
Always return the shutter (
2
) to summer position
.
Do not use the machine in winter operation at
temperatures above +20 °C, otherwise there is
a risk of engine damage due to overheating
3.5.4
At temperatures below -10 °C
Under extreme winter conditions with the following
conditions
–
Temperatures below -10 °C
–
Powdered or drifting snow
use of the "cover plate kit", which is available as a
special accessory, is recommended.
3.5.5
Cover plate kit
The "cover plate kit" contains the following parts for
covering the machine:
4
Cover plate for partially covering the slits in the
starter housing
5
Filter insert made of cloth and plastic for the air
filter
–
O-ring for the filler cap
–
Information sheet describing conversion of the
machine
After installation of the cover plate kit:
.
Set shutter (
2
) to winter operation
.
if the chain saw is extremely cold (frost
formation) – after starting, bring the engine up to
operating temperature at increased idle speed
(cutting attachment rotates!)
3.5.6
At temperatures above -10 °C
.
Reconvert the machine and replace the parts
from the "cover plate kit" with the parts for
summer operation
The O-ring installed on the filler cap with the "cover
plate kit" can remain on the machine.
Depending on the ambient temperature:
.
Set shutter to summer or winter operation
2
317TI010 KN
2
4
5
317TI01
1 KN