Page 26
Technical Information 40.2010
TI_40_2010_13_01_02.fm
.
Unscrew bolts (
1
)
.
Remove blue lead (
2
) and red lead (
3
)
.
Move choke lever to position
}
.
Connect M-Tronic test lead 5910 840 0903 to
the diagnostic jack, see
b
9.4
Connect M-Tronic test lead to Multimeter:
.
Insert black plug in "com" / "ground" jack
.
Insert red plug in "volt" / "ohm" jack
.
Set multimeter to "diode test"
Test diode on micro switch – follow the direction
in the multimeter Instruction Manual:
If the micro switch (switching device) is intact,
readings will match the following target values:
–
Choke lever in position Start
}
– measurement
in direction of flow
Target value: 0.3 volts to 0.7 volts (direction of
flow)
–
Choke lever in position
F
– reverse-biased
measurement
Target value: 1.2 volts to infinity – observe
display, e.g., display [O.L.] or [1.] (reverse bias)
If target values are not attained, check wiring
harness, see
b
9.7.
Replace micro switch (switch gear) if necessary.
9.7
Checking the wiring harness
9.7.1
Checking the ground connection
.
Move choke lever to position
F
.
Measure the resistance between lug (
1
) and
screw (
2
) at the control unit.
Target value: < 10 ohms
9.7.2
Checking leads between control unit and
diagnostic jack
.
Move choke lever to position
F
.
Connect M-Tronic test lead 5910 840 0903 to
the diagnostic jack, see
b
9.4
.
Measure the resistance between red lead (
1
)
and black plug (
2
) of the diagnostic cable.
Target value: < 10 ohms
2
3
5903TI014 KN
1
2
5903TI015 KN
1
2
1
5903TI016 KN