•
Fit starter side of crankcase over
the crankshaft stub.
•
Hold crankshaft steady and
screw the spindle (1) clockwise
onto the stub (2) as far as stop.
•
Hold the spindle steady and
rotate sleeve counterclockwise
until it butts against the ball
bearing.
•
Hold the sleeve steady and
rotate spindle clockwise until the
two halves of the crankcase are
together.
Remove the installing tool.
•
Insert screws and use socket (1)
0812 542 2104 to tighten them
down to 8.5 Nm (6.3 lbf.ft).
Lubricate sealing lips of oil seals
with grease - see 13.2.
•
Fit installing sleeve (1) 4112 893
2400 over the clutch end of the
crankshaft.
Slide the oil seal, open side
facing the crankcase, over the
installing sleeve.
•
Press home with press sleeve
(1) 1118 893 2401.
Remove the installing sleeve.
Slide the oil seal, open side
facing the crankcase, over the
starter end of the crankshaft.
•
Press home with press sleeve
(1) 4112 893 2401.
Assemble as other parts in the
reverse sequence.
Adjust throttle cable - see 7.5.2.
250RA082
VA
250RA079
VA
250RA085
1
VA
250RA080
2
1
VA
250RA083
1
VA
250RA086
1
VA
250RA084
1
VA
250RA081
VA
)6)5
Summary of Contents for FS 350
Page 1: ......