INSTRUCTION MANUAL
GB
–
1/6
- DOC NO. BE0455020-A
USE
- The VIGIBELT
®
CDM80 is a belt alignment control system for buckets elevator. It helps prevent friction between the
strap and the inside of the elevator leg. The VIGIBELT® CDM80 detector must be installed in pairs on the side of
the riser leg of the elevator and just above its foot. If the elevator is more than 20m high, it is then recommended to
add a pair of VIGIBELT® CDM80 just below the head, still on the riser.
- We recommend placing an EAZY> DETEC target (STIF product) every 30 meters on the belt to allow precise
detection by the VIGIBELT® CDM80. The EAZY> DETEC metal target should be installed in place of a plastic
bucket.
DESCRIPTION
- The VIGIBELT
®
CDM80 is composed of two sensors, an calibration tool, a background metal sheet and the fixing
screws.
Possible adjustment for the VIGIBELT
®
CDM80
- The VIGIBELT
®
CDM80 is intended to be programmed for detection distances of 15 to 35 mm (with a pitch of 5mm)
between the inside of the lift leg and the target bucket
PRECAUTIONS
The VIGIBELT
®
CDM80 kit must be installed, connected and put into service only by competent personnel. The
staff must have electrical authorizations, know the regulations and provisions concerning the installation of these
devices, especially for the Ex II3D version integrated in ATEX zones.
- Carry out beforehand an electrical connection study to install the VIGIBELT
®
CDM80 (standard electrical diagram,
power supply and electrical protection, plc control, ATEX zones).
-
Check that the temperature range of use of the VIGIBELT
®
CDM80 (variable according to version) corresponds
to your application.
-
Check during the first commissioning of the bucket elevator in the handling phase, that there is no sealing defect
(dust leak) between the sheath of the elevator and the VIGIBELT
®
CDM80.
-
Bring the bucket elevator or belt conveyor to a stop (off-powored) before any installation or intervention on the
VIGIBELT
®
CDM80 (intervention information to be indicated on the machine).
Z.A. de la lande - 49170 Saint-Georges-sur-Loire - France
Head office, purchasing and factory:
tel: +33 2 41 72 16 80 - Fax +33 2 41 72 16 85
France Export Sales Service:
tel.: +33 2 41 72 16 82 - Fax +33 2 41 39 32 12
email:
- Website:
SAS with a capital of € 800,000 - R.C.S. Angers B 328 876 503 - 84B12 APE 2511Z - VAT number FR 35 328 876 503
2X
CDM80
1X
FLAT BACK SHEET
M6 SCREWS
1X CALIBRATION
TOOL
