Operating Manual
RC-3030
17
*An authorized electrician must verify proper voltage before turning on the machine!
Damage to VSD will occur if voltage is incorrect.
5.2
Initial Operation
All persons near the machine must wear safety glasses with lateral protection, ear
protection as well as safety shoes. The operator is obliged to wear close fitted protective
clothing.
Before start-up the operating personnel must be familiar with the safety regulations given in this
manual.
Attention! Before you plug the equipment to a power supply make sure the power supply
is equivalent to the data shown on the machine label.
Initial operation of the grinding machine:
1. Attach the appropriate tools on the tool plates.
2. Connect the machine power plug to the required power source.
3. Assure the dust hose is connected correctly to filter and machine.
4. Switch on the filter unit.
5. Check that the main switch is turned on.
6. Turn the Main Power switch to “On."
The machine can be operated manually through the handle’s control panel, or automatically through
the remote controller. Refer to Chapter 6 "Operation of Machine" for preferred mode of operation.
7. After start-up, immediately begin moving the machine in the "S-Curve" pattern
(see page 9 –
Chapter 3.3 for explanation)
to prevent the tools from digging into the concrete surface and
creating an uneven profile. For the operation of the running machine, it is necessary to move
the machine in the "S-Curve" to create an even cut that is consistent in flatness and profile.
Only push machine in a straight line when grinding or polishing an edge.
8. When grinding in work area is complete, follow the instructions for stopping the machine.
9. The dustbin of the filter unit needs regular dumping.
Do not overfill the bin to avoid dust exposure when opening the bin. Comply with the
local waste treatment regulations considering the removed material.