RC-3030
Operating Manual
12
3.7
Electric Motor
The power plant of the P/M grinder is the electric motor. The motor is responsible for turning the
gears which turn the abrasive tools on the floor. The motor is controlled exclusively by controls on
the back, handle, and remote controller which inputs specific power to generate a given RPM.
3.8
Robotic Wheels
The Robotic wheels are controlled by two smaller drive motors
for remote control operation. The two knobs control the state of
the wheels. Set the wheels into a "locked" state for remote control
operation, or "unlocked" state for manual control operation.
3.6
Handle Settings
The handle height is set with the help of two
spring-loaded knobs on each side of the handle
joint. To move the handle up or down:
1. Pull out the knobs on both sides of the
handle joint by twisting clockwise or
counter-clockwise 45 degrees to place
knob in a disengaged position.
2. Move the handle to the desired position,
and then twist knob clockwise or counter-
clockwise to reengage locking feature.
Handle's Varied Positions
1. Upper Position:
1) for tipping machine back; and 2) to make tool change
2. Middle Position:
1) for manual control of machine
3. Lower Position:
1) for remote control; and
2) transportation of machine
Upper Position: for tipping
machine back & tool change
Middle Position:
for manual operation
Lower Position: for remote
operation and transportation
