STF-Filtros FMA-2000 series, Installation, Operation And Maintenance Manual

Page: 29 / 47

Installation, operation and maintenance manual - FMA 2000
Ref: 2000/CPF01/230/VH 29

PASSWORD: It allows you to have access to the program, it is protected to avoid non-
authorized modifications by the manufacturer.
 RUN / STOP: It allows you to stop the running cycle when the STOP key is pressed.
The symbol
 appears next to the present condition on the LCD screen. Use keys  in order
to change it and select STOP RUN (a flickering appears) and press OK.
 PARAMETERS: It allows you to have access to the installation modifiable parameters
Press keys
 in order to select the PARAMETERS (a flickering appears) and press OK. The
parameters are the following:
T5– Time between backwashings
It shows the backwashing time in hours and minutes. These figures turn back to zero every time a
manual or automatic backwashing is carried out. This valor can be modified according to
installation needs.
 I1 – Backwashing time value in hours and minutes (H:M)

T – Time in hours and minutes (H:M) since last backwashing
Press keys

to move over I1. Press OK to modify values by using keys

and
 
.
When finished, press OK in order to accept the new value.
Press ESC to quit.
C8 – Language selection meter.
It allows you to select the language of the messages monitorized by the programmer. It can be
done in Spanish and English.
o
1 – Spanish (standard)
o
2 – English
Press keys

to move over I1, press OK to modify values by using keys

and
 
.
When finished, press OK again to accept the new value.
Press ESC to quit
C15-Consecutive backwashing meter
It shows the consecutive automatic backwashings number during which the pressure switch
keeps sending a continuous signal.
In this case the value is 20. At the moment when the
consecutive automatic backwashings get this value, the filter will go into alarm. (Consult ALARM
section)