STF-Filtros FMA-2000 series, Installation, Operation And Maintenance Manual

Page: 27 / 47

Installation, operation and maintenance manual - FMA 2000
Ref: 2000/CPF01/230/VH 27
12.2. – PERFORMANCE
The start screen shows the following information, the upper parameters...3.4... indicate the entry
signals
into the programmer.

Paramater 1 – Manual backwashing pushbutton
 Parameter 2 – Pressure switch.(Pressure transducers are used by default)

Parameter 3 – Front limit switch. Filter 1

Parameter 4 – Back limit switch. Filter 1
Besides this, the date and time appear on the display, (RUN) if the programmer is on or (STOP) if
it is stopped. In the event of the equipment is stopped it will not make backwashing cycles. P
indicates the push-button
Start screen image
When a backwashing cycle starts a screen that monitors the time in seconds and milliseconds
appear. When the cycle finishes the start screen appears again.
Filter backwashing screen image
Pulse to check the time that has passed from the last backwashing (it appears in hours and
minutes) and the total equipment backwashings number by pressing the key

or

while the
start screen is on.
Last backwashing & total backwashings screen image