30
case
The LED mounting bezel consists of two main parts: A ring that
the LED fits into, and a plastic plug that goes over the LED from
the back side to keep it in place.
Install the mounting bezel through the front of the enclosure. From
the inside, slip a lock washer and nut on and tighten it up using a
3/8" wrench. Insert the LED into the bezel so that the two leads are
parallel with the top and bottom of the housing and the shorter
lead is closest to the outside of the enclosure. Feed the leads
through the plastic plug, press the plug down until it’s tight in the
bezel. The LED will be held in place when you solder the leads to
the switches and circuit board. For a more secure mount, you can
run a bead of clear silicone adhesive around the plastic plug.
Repeat above steps for red and white LEDs.
INSTALL
2 LED
INDICATOR
LIGHTS
15
15
Like some of the caps and diodes, the LED is
polarized and has to be installed in a specific
direction. The negative lead of the diode has a flat
edge and is shorter than the positive.
5mm LED mounting bez
el (1)
#7432
5mm white LED (1)
#7422
case
+
+
