Final Assembly
(continued)
67.
Feed motor lead through F2, F3, and motor mount F8.
68.
Remove covering over battery compartment. Feed battery lead down through F2 and F5,
and out the opening for the battery compartment.
69.
Mount the recommended SA-SPORT Park BL180 motor [SUPA1504-18] to F8 with three #2
x 1/4 screws. Place one nylon washer under the left mount to create the proper right offset
for the motor. Mount GWS 5x3 HD propeller to motor shaft.
70.
Temporarily install main wing. Now, dry fit the horizontal and vertical stabilizers to the
fuselage. Slide the vertical stab. through the horizontal stab. and fuselage, securing the
long tab in the slot in F19, and the short tab in the slot in F20. Square assembly
perpendicular to the fuselage and each other, and bond in place with medium CA. Remove
wing.
71.
Follow the General Pushrod Detail on the wing plan sheet to finish the pushrods at the
rudder and elevator.
72.
Remove covering from the wing over the servo pockets and exit hole W9. Mount the
aileron servos [SPMAS2000] within the servo pockets in the wing. Feed the servo leads
down through the pocket, through Ribs W2 and out exit hole in W9. attach servo leads to a
“y” harness [SPA2002] or two 3 in. extension leads [SPA2000], and plug into one of the
aileron ports - refer to receiver diagram on plans.
Note: The servos may initially operate together in the same direction. To correct this, follow
the Servo Reversing instructions on the wing plan sheet, or on the servo manufacturer’s
web site.
Install the aileron control horns “A” to the underside of the ailerons. Follow the “General
Pushrod Detail” on the wing plan sheet to create and connect the pushrods for the ailerons.
Mount pushrods in the outer holes on the aileron control horns for initial flights.
73.
Mount the self-adhesive backed vinyl color pilot profiles to the balsa profile P. Fit and bond
pilot figure in slot in F2 within Cockpit.
74.
Mount wing using two fresh #16 rubber bands.
Complete!
Adjust balance of model by moving battery within battery tray, or adding a bit of modeling clay within nose
of model. Important! Model must balance 1/8-1/4 in. behind the main wing spar (see plan sheet for
balance point).
Congratulations! Your Swift (100) is complete! Follow the Flight Control Setup to prepare your Swift
(100) for flight.
Build Instructions
Swift (100)
- Build Instructions © 2014 Stevens AeroModel, all rights reserved.
!
Page 26
□
□
□
□
□
□
□
□