Wing
(continued)
44.
Locate the laser cut strips of 3/32 square balsa W9a (sheet 07/09, 3/32 in. balsa), W9b
(sheet 07/09, 3/32 in. balsa), and W10 (sheet 07/09, 3/32 in. balsa). Fit W9a and W9b in
the notches over the spar and bond to the spar and ribs with medium CA. Fit W10 in the
notches in the forward portion of the ribs and nesting within slot at wing tip. Bond with
medium CA.
45.
Fit and bond W11 (sheet 02/09, 1/20 in. balsa) to the bottom of ribs W2
46.
Fit and bond the
left
and
right
ply servo mounting plates W12 (sheet 09/09, 1/32 in. ply) to
the notches in
left
and
right
of spar W1 and ribs W5.
47.
Bond the
left
and
right
balsa servo cuffs W13 (3/16 in. balsa) to the BOTTOM of each
left
and
right
servo mounting plate, to create a pocket for the servo to rest in.
48.
Fit ply trailing edge reinforcement W14 (sheet 09/09, 1/32 in. ply) within notch of part W4 at
trailing edge of wing. Bond with medium CA glue.
49.
Use the detail sheet as a guide for proper positioning of balsa diagonal sub ribs W15 (sheet
05/09, 1/16 in. balsa). Fit right and left sub ribs to assembly, hold wing flat against your
building board and bond with medium CA to retain parts.
50.
Sand the leading edge to shape. Match the contour of the leading edge to fit the wing
saddle on the fuselage. Flow the leading edge smoothly into the wing tip.
51.
Dry assemble ailerons from parts A1 through A5 (sheet 06/09, 3/32 in. balsa). Bond with
thin CA. Following the “Elevator and Aileron Tape Hinge Diagram” on wing plan sheet,
bevel the underside of the leading edge of the ailerons at a 45 degree angle. Note: Ensure
that you sand the leading edges on the correct side so that you will end up with a LEFT and
a RIGHT aileron.
Build Instructions
Swift (100)
- Build Instructions © 2014 Stevens AeroModel, all rights reserved.
!
Page 20
□
□
□
□
□
□
□
□