18. Laminate the three (3) part S1D (spar doublers) to the back side of the spar re-enforcing the mid section and
each finger joint between R2 and R3. See plan sheet and illustration for details on placement.
19. Install part W2 center brace between interlock points of the trailing edge jig TE1.
20. Remove the wing riser jigs.
21. Sand leading edge – round to match shape of airfoil. See plan sheet for more detail
22.
IMPORTANT!
Test fit the wing to the Fuselage and inspect for proper fit. Sand trailing edge of wing to fit
fuselage wing saddle.
© 2004 Stevens AeroModel.
27
