Final Assembly Continued
48.
Push Rods and Receiver - Refer to the Pushrod Detail on the Detail Sheet. Make a ‘snake
bend’ in one end of a 12 in. long piece of .015 wire.
49.
Feed the straight end of the wire through the hole marked ‘R’ (for Rudder) on the
left
side of
former F12.
50.
Continue feeding the push rod through the hole marked ‘R’ on the
left
side of former F13.
51.
Slit the covering over the rear portion of the
upper
exit slot in the
left
side of the fuselage,
and pass the pushrod through the slot.
52.
Connect the ‘snake bend’ of the push rod to the center hole of the rudder servo, which is the
servo nearest the antenna.
53.
Repeat step 48, and make a ‘snake bend’ in one end of the remaining length of .015 wire.
Pass the straight end of this pushrod through the hole mark ‘E’ (for Elevator) on the
right
side of former F12.
54.
Continue feeding the pushrod through the hole marked ‘E’ on the
right
side of former F13.
55.
Slit the covering over the rear portion of the
lower
exit slot on the
right
side of the fuselage,
and pass the push rod through the slot.
Build Instructions
1911 Cuadron Build Instructions. © 2013 Stevens AeroModel all rights reserved.
!
Page 20
□
□ □
□
□
□
□
□
□
