Fuselage Continued
25.
Fit former F21 to the notch immediately behind former F20. Ensure that both formers are
perpendicular to the surface of F1, then bond them to each other and F1 with thin CA.
26.
Locate the three slots spanning the mid-section of F1. Fit former F22 to the wide center
slot. Fit former F23 behind F22, engaging the two outer slots. Ensure that both formers are
perpendicular to the surface of F1, then bond them to each other and F1 with thin CA.
Do
not
allow glue to fill the notches around the top of former F23.
27.
Fit and bond former F24 to the inner portion of the notches in F1b, shared by former F13
below.
28.
Fit and bond parts F25a and F25b together to create the nose sheeting.
29.
Moisten the top surface of F25 with glass cleaner, and allow it to soak in for a minute or two.
Fit F25 to the tabs in F19 and F20, moist side out. The front of F25 will lie flat along the top
of F19. The rear of F25 will wrap around the top of former F20. Hold F25 in place with low
tack masking tape until completely dry.
30.
While F25 is drying, Moisten one side of the cockpit sheeting F26 with glass cleaner and
allow to soak for a minute or two.
31.
Fit F26 to the tabs on formers F21 and F22 - the part is symmetrical, so it doesn’t matter
which end goes in front. Wrap F26 around the top of the formers and hold in place with low
tack masking tape until completely dry.
32.
When F25 and F26 are completely dry, remove the tape and bond them to the formers and
fuselage sides with a slow setting CA glue.
Build Instructions
1911 Cuadron Build Instructions. © 2013 Stevens AeroModel all rights reserved.
!
Page 14
□
□
□
□
□
□
□
□
