8
FlOW TIME aDJUsTMENT
How to adjust the flow time in Touch bRE
1) disconnect the transformer.
2) While the power source is disconnected,
verify that the solenoid valve is installed and
touch the piezo cap twice.
3) then, reconnect the power supply.
4) the light ring at the Piezo cap will start
blinking. after a few blinks the light ring
will give a steady light. touch the Piezo cap
when the steady light is still on to enter into
adjusting mode. When done correctly, the
light ring will stop blinking.
Note
: If you will not press at the indicated area, the
previous adjustment will remain.
5) By touching the Piezo area in the middle of the light ring at the Piezo cap
the new flow time will be programmed. In adjusting mode level 1, each touch
increases the flow time by 1 second with a maximum of 10 seconds. You will
see the light of blinking every time that a new step is performed.
6) If your desired flow time is within 10 seconds, no other adjusting levels
are needed and you can stop pressing the Piezo cap. the light will blink 2
times, then 3 times and after 4 times you will leave the adjusting mode. the
touch BRe is now adjusted to the desired flow time.
7) If you need to perform steps at the adjusting level 2, wait after you see the
light blinking twice and then, perform the needed quantity of steps (with a
maximum of 10 steps of 2 seconds)
8) If you do not need more levels, stop pressing. the light will blink 3 times,
and after 4 times you will leave the adjusting mode. the touch BRe is now
adjusted to the desired flow time.
9) If you need to perform steps at the adjusting level 3, wait after you see the
light blinking 3 times and then, perform the needed quantity of steps.(with a
maximum of 2 steps of 15 seconds)
10) to leave the adjusting mode wait until the light blinks 4 times. the touch
BRe is now adjusted to the desired flow time.