8
9
MF lIquId deck Mounted SoaP dISPenSeRS
INSTALLATION
MF lIquId wall Mounted SoaP dISPenSeRS
INSTALLATION
STEP 1 – INSTALLING THE MF SOAP DISPENSER
1
Drill a hole at the desired location on the
wall according to the MF soap dispensers
recommended hole size specified in the
‘Technical Data’ section of this manual.
drill a small hole (4 mm) just above
the main installation hole. consult the
relevant technical drawing.
Remove the hexagonal nut and the disk
from the base of the soap dispenser
spout.
Recommended
hole size
16mm
23-24mm
2
Insert the Soap dispenser base and the
anti-rotation pin into the drilled holes.
Fix the base behind the wall with the
hexagonal nut and the disk.
SOAP DISPENSER BASE
DISK
ANTI-ROTATION PIN
HExAGONAL NUT
3
Fix the soap pump using its support to
the desired location.
IMPoRtant:
Make sure the soap pipe from the pump is cut to the length required by
the installation.
4
Connect the soap tube that extending
from the soap dispenser body to the
quick connector at the top of the soap
dispenser pump by snapping it in.
STEP 1 – INSTALLING THE MF SOAP DISPENSER
1
Drill a hole in the deck or lavatory
according to the MF soap dispensers
recommended hole size specified in the
‘Technical Data’ section of this manual.
drill a small hole (4 mm) just beside
the main installation hole. consult the
relevant technical drawing.
Remove the nut, disk and gasket from
the base of the MF soap dispenser body.
Recommended hole size
Max 30mm
Min 26mm
If your dispenser is supplied with
anti-rotation solution, drill an
additional hole for anti-rotation pin.
2
Install the soap dispenser body along
with the bottom ring into the hole in the
deck or lavatory and slide the gasket,
disk and nut over the soap dispenser
body nipple and secure it.
3
Fix the soap pump using its support to
the desired location.
IMPoRtant:
Make sure the soap pipe from the pump is cut to the length required by
the installation.
4
Connect the soap tube extending
from the soap dispenser body to the
quick connector at the top of the soap
dispenser pump assembly by snapping
it in.