4
5
fLUSH VALVe INSTALLATION
fLUSH VALVe INSTALLATION
1
Ensure that the central water
supply has been turned off at the
corner valve.
2
Install the flush valve on the wall
connected to the mains water supply.
Fit the wall flange between the inlet
opening of the regulating valve and the
surface of the wall.
WALL FLANGE
WATER
SUPPLY PIPE
NOTE: Use the sealing thread or Teflon tape to seal the screw thread connection.
3
Insert the inlet pipe and rubber
seal into the opening in the urinal.
Push the inlet pipe into the water
outlet opening of the flush valve
and tighten the locking screw
LOCKING SCREW
4
Turn on the mains water supply
again and check the installation
for leaks.
5
Ensure that the regulating valve
is fully open by turning it anti-
clockwise.
6
Remove the sticker that is covering
the sensor. The battery is already
connected and the flush valve is
now operational.
IMPORTANT:
Carry out functional check. If the sensor coverage area is not adequate it can be
readjusted following the procedure in the “Settings adjustment” section.
