8
9
bATTery rePLACemeNT
1
Turn off the regulating valve
2
Unscrew the cover of the electronics
unit and remove it.
3
Replace the old battery with a
new 9V battery (lithium battery
recommended).
NOTE: Check that the outer O-ring is not damaged. Replace the O-ring if necessary.
ATTENTION: Dry the inside of the cover and interior of the flush valve body carefully.
The interior of the flush valve body and the cover plate with the electronic cap must
be fully dry before reassembling the parts.
4
Replace the electronic unit cover
and screw it tight.
Open the regulating valve once
again.
mAINTeNANCe
Important:
Spent batteries should not be disposed of with normal
household waste. Contact your local authority for information on waste
disposal and recycling.
FIlteR CleANINg INStRuCtIoNS
This flush valve is provided with a steel filter preventing foreign particles to enter the
lines. If the water flow has decreased, this can be because the filter is clogged.
the filter can be cleaned as follows:
1. Turn-off the regulating valve.
2. Disassemble the electronic flush valve from the regulating valve.
3. Remove the filter and wash it under running water.
4. Reassemble the filter.
5. Reassemble the electronic flush valve.
6. Turn on the regulating valve and adjust the flow capacity.
7. Make sure that there is no water leakage.
CARe ANd CleANINg oF CHRoMe ANd SPeCIAl FINISHeS
DO NOTuse steel wool or cleansing agents containing alcohol, acid, abrasives, or the
like. Use of any prohibited cleaning or maintenance products or substances could
damage the surface of the flush valve. For surface cleaning of flush valve use ONLY
soap and water, then wipe dry with clean cloth or towel. When cleaning bathroom
tile, the flush valve should be protected from any splattering of harsh cleansers.
